Grouping watch models by size

By following these steps, you can easily group watch models with different sizes in Studio for more organized and efficient management.

To include a model in the group, you have two options:

1. Initial uploading with correct naming: When initially uploading the models, make sure to use the appropriate naming convention with the size specifier included. This way, the models will be automatically grouped.

2. Renaming after uploading: If you have already uploaded the models without the size specifier, you can still include them in the group. After loading, simply rename the models by adding the size specifier using double underscores (__). The models will then be included in the group automatically.

If there is only one model:

Uploading models with different sizes:

Try on with/without wrist measurement

You can either select an individual model from a group or choose the entire group.
Once you've selected a model, you can generate a QR code to try it on.
When using the web try on, you have two options: fitting with or without wrist measurement.
- If you choose fitting without measuring your wrist, all models will be displayed separately.
- If you choose fitting with a wrist measurement, only one model will be shown, which is sized slightly larger than reality based on the measured wrist size.

Additional Information

1. Publishing Models Separately: You have the option to publish models separately within a group. When you do this, you will notice an identifier appearing in the group. This identifier indicates that there are models in different statuses.

2. Renaming the Group ID: If you decide to rename the ID of a group, please note that the IDs of all models included in that group will also change. However, this applies only if all the models within the group have not been published.